This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
en:users:drivers:ath10k:codingstyle [2018/04/13 11:11] Kalle Valo Add section for debug messages |
en:users:drivers:ath10k:codingstyle [2018/04/13 11:16] Kalle Valo Add section for error message |
||
---|---|---|---|
Line 145: | Line 145: | ||
* Bar | * Bar | ||
*/</code> | */</code> | ||
+ | |||
+ | ==== Error messages ==== | ||
+ | |||
+ | For warning and error messages we have ath10k_warn() and ath10k_err(). | ||
+ | |||
+ | ath10k_warn() should be used when ath10k still continues to work, for example then some limit has been reached or an unknown event has been received. It's also rate limited. | ||
+ | |||
+ | ath10k_err() should be used when a fatal error has been detected and ath10k will shut itself down, for example during driver initialisation or firmware recover fails. It is NOT rate limited. | ||
==== Debug messages ==== | ==== Debug messages ==== |